FAQ

They are made from High quality pure ABS virgin automotive grade that are high impact with enough flexibility and rigidity for everyday use. They come with complete UV protection and are further backed by a Limited Lifetime Warranty against cracking, warping, bad craftsmanship, or other factory related defects that may arise.

The PAINTABLE finish Fender Flares offered by PSI can easily be prepped and painted. In addition the the regular paintable finish where painting can be done post purchase, we also offer FULLY PAINTED products from our store. If you fail to see the proper paint code, please send aus a message and we can verify the paint code you have on your vehicle. If you do decide to paint yourself, we strongly encourage a clear coating after painting with an official automotive paint.

For every order of Fender Flares purchased from PSI Auto Restyling will come with a complete set of four fender flares, or in some case, separate boxes with a rear pair and a front pair, all relevant mounting hardware (decorative hardware as well if it applies), a complete roll of rubber seal with 3M tape, and a complete instruction sheet for full installation.

PSI Auto Restyling Fender Flares are fairly easy to install. All relevant mounting and decorative hardware will be supplied. You will existing factory holes in the inner wheel well. If factory holes are not available, self tapping screws will also be provided so that the flares can directly mount onto the sheet metal for a stronger fit.

We strongly encourage our customer to remove the moldings prior to installing the fender flares to help ensure the best possible fit.

We strongly suggest you use a fair combination of mild soap and water. It is of great importance that you do not use any chemicals or cleaning agents to clean the fender flares. Using these chemicals may affect the flares finish and overall color.

Yes! We do offer the BLACK Decorative HARDWARE kit as an alternative. It is located in our store and available for any and all of our POCKET Style, Cut Round Style, and POP-OUT Style Fender Flares.

Yes. It is of paramount importance that you use the supplied roll of rubber seal onto the top edge of the flare. It will help fill in to the contour of the fender as well as protecting the fender if installed correctly. Do not paint the seal as it is made of rubber and paint will be very hard to stick.

Open up the package and ensure that all items are accounted for and please inspect the product for any damages that may have incurred during shipping. Upon successful inspection and before you actually start the installation process, please PREFIT the flares onto the vehicle’s boy to help minimize problems that may arise during installation.

ALL PSI Fender Flares will install onto the fender panel and will require the removal of existing fender flares (like OE) . The FJ Cruiser will be the only exception to the rule. This set will install over EXISTING OE style fender flares.

Yes, we understand accidents happen and we are here to help you ensure that you only need to spend the least amount of money to fix your problem. Whether that be finding a replacement piece or if you need new hardware or seals, please send us a message and we can help!